Zoom All (Ctrl+A)
Zoom Window (Ctrl+W)
Zoom Out (Ctrl+T)
Zoom at Point
Zoom Limits (Ctrl+L)
Zoom Extents

 

 

 

 Use this command to display the extent of the visible part, sketch or drawing sheet.

 Use this command to enlarge the display of a window area by selecting two diagonal points.

 Use this command to zoom out (i.e., show more of the active object) by selecting two points to define a zoom window. The display will zoom out where the window is located. The zoom factor is based on the size of the window in relation to the current zoom factor. Pick two diagonal corners of a zoom window.

 Use this command to zoom in on a selected point. This command stays active so that you can repeatedly select location on the screen to control the zoom location and zoom factor. Middle-click to end the command.

Use this command to re-display the active drawing sheet to its set limits.

 Use this command to set the current view extents. The Set View Extents Form is displayed showing the current extent value.

Return to an exact Zoom Level

Set the zoom factor the way you want it using any of the zoom commands and then make a note of the resulting view extent value using this command. Later if you want to return to that zoom level, use this command and the enter the view extent value.